Version 4.2.6
 —  Operations  —

Terminating the Global Swap Pool under UTM

This document describes the ways in which a Natural global swap pool can be terminated under UTM.

The following topics are covered:

Warning:
Before the swap pool is terminated, the Natural under UTM application that uses it must be terminated.

Termination Using Console Commands

Start of instruction setTo terminate the global swap pool normally

  1. Issue the console command:

    /INTRtsn,STOP

  2. or issue the console command:

    /INTRtsn,END

Top of page

Abnormal Termination with Dump

Start of instruction setTo terminate the global swap pool abnormally, producing a dump

The swap pool is terminated abnormally and a dump is produced.

Top of page

Termination by Program

Start of instruction setTo terminate the global swap pool normally, using the program CMPEND

Top of page