Version 4.2.6
 —  Messages and Codes  —

Entire Transaction Propagator Abend Codes

The ABEND codes described here can occur during the operation of the Entire Transaction Propagator CICS Interface (product code: ETC).

If one of the following ABENDs occurs, it may be hidden if a CICS ABEND exit is set (e.g. within Natural). In any case, the error message is written to the operator console and to the CICS job log.

Code Explanation
ETC0 An ETC internal error occurred. Contact your Software AG support representative.
ETC1 The parameter module ETCPARM is not linked to ETC.
ETC2 ETPNUC has not been linked to ETC.
ETC3 The module specified in the ADANAME parameter of the ETCPARM macro call could not be loaded.
ETC4 The CICS level types of the module resulting from the linkage step and ADALNC must be the same. Both must be either command- or macro-level; a combination of the two is not allowed.
ETC5 The module specified in the ADANAME parameter of the ETCPARM macro call is not an ADALNC macro-level module from a supported Adabas version.
ETC6 The CICS version on which ETC was installed is not supported.
ETC7 The ETCNUC and ETCPARM versions do not match.
ETC8, ETC9 An ETC internal error occurred. Contact your Software AG support representative.
ETCA The TWA does not exist or the TWA length is not sufficient.
ETCB All PUSER slots are exhausted or the user-specific slot could not be found.
ETCC EXECKEY (CICS) has been set for ETC. EXECKEY (USER) must be set.

Top of page