This document covers the following topics:
The ETP asynchronous tasks resynchronize replicate files with their master files only when the tasks are started/restarted. If no self-restart interval is defined for the replicate transactions or if no ET time user program starts the task, you must start the task manually (see the Replicate Transactions function) to apply any unapplied master file changes to the replicate files. This function stops all active tasks at a point where no interruption occurs for the resynchronization process.
Note:
Asynchronous tasks that clean up log files are affected by this
function in the same way.
By either entering the COntrol TAsk direct command or selecting the
CO task on the ETP main menu, the
Control Execution of Asynchronous Tasks screen
appears.
23:59:59 ***** ENTIRE TRANSACTION PROPAGATOR ***** 2000-12-24
Control execution of asynchronous tasks
To stop all asynchronous tasks which use the current
administration file, enter Y below. All executing tasks
are stopped when they finish execution on their assigned
range of files. If any task is started or self-restarted
before task execution is re-enabled, the task is stopped
immediately.
Note: Asynchronous task control affects tasks that
- replicate transactions
- clean up log files.
To re-enable execution of asynchronous tasks, enter N
below, save the change and restart the tasks manually.
Stop all asynchronous tasks N (Y/N)
Command ===>
Enter-PF1---PF2---PF3---PF4---PF5---PF6---PF7---PF8---PF9---PF10--PF11--PF12---
Help Menu Exit Last Flip Tech Canc
|
| Stop all Asynchronous Tasks | Specify Y to stop all tasks under control of the
active administration file. Setting this value to N re-enables
(but does not restart) the tasks.
|
