The Software AG Editor provides two types of command for controlling your editing session:
Main commands refer to the entire data currently contained in the source work area of the editor. The main commands available to you depend on the application you are using.
The command format in the examples provided in the Software AG Editor documenation show the abbreviated form of each main command. These examples are by no means exclusive. For a complete summary of command syntax, see the section Summary of Main Commands.
Line commands refer to the source line on which they are entered or to a block of data delineated by line commands.
For a complete summary of line commands, see the section Summary of Line Commands.
Commands are processed in the following order:
Data updates
Line commands
Main commands
Depending on the configuration of your installation, main commands and line commands can be entered in lower case. In the command descriptions provided in the Software AG Editor documentation, all commands appear in upper case to distinguish them as commands.
To execute a main command
In the command line (COMMAND===>), enter a main command and press ENTER.
You can enter several commands in the same input operation if you separate them with a semicolon (;).
To execute a line command
In the leftmost column of the prefix area, next to the required source line, type a line command over the characters contained in these columns, and press ENTER.
When you press ENTER, apostrophes ('''''') or
asterisks (******) are replaced by line numbers on used lines.
Unused lines are automatically deleted.
Or:
In the first column of the editing area, enter a line command
preceded by the escape character and press
ENTER. The default escape character is the period (.).
Or:
In the command line, enter a line command preceded by a colon
(:).
The cursor then marks the line to be addressed. Press ENTER.
