TLINJES Interface

This message is associated with Com-plete's JES interface. It indicates that the JES Interface Module designated or implied by the JES=startup parameter returned a non-zero return code in response to a request from initialisation module TLINJES. This request was to initialise the JES interface.

If a critical error occurred (return code 8), Com-plete initialisation is aborted. If a non-critical error (return code 4) system initialisation continues, the JES interface is disabled.

This message is caused by an error within the JES Interface Module selected for use at your site. Further investigation of the error is required.

This message is associated with Com-plete's JES interface. It indicates that either Com-plete's JES functions have been disabled by use of a null JES= startup parameter or an error condition described by a previous ZIJ000x message occurred while attempting to initialise the JES Interface Module (JIM).

The Com-plete system continues normal initialisation. All Com-plete functions that use the JES interface (the RJE function and some UQ utility program operations) are disabled.

If this message was caused by a previous error condition initialising the JIM, refer to that message for details.

This message is associated with Com-plete's JES interface. It indicates that the explicit or implied JES= startup parameter names a module that does not exist in Com-plete's load library.

Normal Com-plete initialisation continues, but the JES interface is disabled.

JES interface module names begin with the characters 'TTJI' by the implied or explicit JES= startup parameter. Make the correct module available or change the value of the parameter and restart Com-plete when convenient.

This message is associated with Com-plete's JES interface. It indicates that a permanent error was detected on the library that the selected JES Interface Module is stored in.

Normal Com-plete initialisation continues; however, all JES functions will be disabled.

The appearance of the message indicates that a serious problem exists with one or more of Com-plete's load libraries. Investigate to determine whether the load libraries are in usable condition. Restart Com-plete when the damage has been repaired.

This message is associated with Com-plete's JES interface. It indicates that the JES PUT/ENDREQ module does not exist in the Com-plete load library.

Com-plete initialisation continues, the JES interface is disabled.

Check why the module is not available in any of the load libraries accessible by Com-plete and make it available.

The JIM initialisation routine returned code '$'.

Com-plete initialisation continues, but the JES interface is disabled.

Contact Com-plete support for an explanation of code '$'.