CATALOG [object-name
[library-id]]
|
Related commands: SAVE
|
STOW
.
This command is used to catalog (compile) the source code currently in the work area of a Natural editor and (if the syntax has been found to be correct) store the resulting cataloged object in the current Natural system file.
See also:
Natural
Compiler in Natural System Architecture
Object
Naming Conventions in Using
Natural
Important:
The CATALOG
command cannot be used if the profile
parameter RECAT
has
been set to ON
; in this case, use the STOW
command to compile and store the
object.
CATALOG |
If you do not specify an object-name, the object is
cataloged in the current library under the name of
the object last read into the source work area (for example, with
|
CATALOG object-name
|
A new object is created. As object-name, you specify the name under which the new object is to be cataloged. It is stored in the current library. If the object exists, the command is rejected. |
CATALOG object-name
library-id |
If you want the new object to be cataloged into another library, you must specify the library-id of that library. If the object exists, the command is rejected. |
Note:
If an FDIC
system file is specified in the parameter module which is not valid, Natural will
display an appropriate error message when the CATALOG
command is
issued.