This Natural profile parameter can only be specified with the NTIMSP
macro,
dynamic parameter specification is not possible yet.
The NTIMSP
macro is used to set general parameters for the Natural IMS TM
Interface.
The NTIMSP
macro can be specified only once in the Natural parameter
module.
Possible settings | See below. |
---|---|
Default setting | See below. |
Dynamic specification | no |
Specification within session | no |
This section covers the following topics:
The NTIMSP
macro is specified as follows:
NTIMSP NIINAME=value, * SUBPOOL=value, * THRELO=value, * TRNCODE=value
NIINAME
| SUBPOOL
| THRELO
| TRNCODE
NIINAME=value
specifies the name of the Natural
IMS TM Interface module to be used by the current driver.
Value | Explanation |
---|---|
1- 8 characters | A valid module name. |
NIIINTFM |
This is the default value. |
SUBPOOL=value
specifies the z/OS subpool to be
used for storage requests.
Value | Explanation |
---|---|
0 - 127 |
The number of a z/OS task-related subpool used by a problem state program. |
125 |
This is the default value. |
THRELO=value
determines whether the Natural
storage thread can be allocated at a different virtual address after a terminal I/O.
Value | Explanation |
---|---|
ON |
Thread relocation is enabled: the Natural thread can be
allocated at a different virtual address after a terminal I/O.
This is the default value. |
OFF |
Thread relocation is disabled and the Natural thread
remains at the same virtual address.
The size of the Natural thread is determined by the first Natural session that allocates the thread. As a consequence:
Note: |
TRNCODE=value
can be used to identify the
transaction code.
Value | Explanation |
---|---|
ON |
The TRNCODE keyword subparameter is activated
to evaluate the TRNCODE parameter:
|
OFF |
The TRNCODE keyword subparameter is
deactivated.
This is the default value. |
NTIMSP NIINAME=NATIMS1,SUBPOOL=0