%H
|
destination |
These terminal commands are used to produce hardcopy output from Natural reports on a printer or special destination, such as the source area.
Note:
The commands are only valid if the hardcopy feature is
implemented.
By default, a %H
command is effective for
the current logical output (that is, the current window without message line,
function-key lines and statistics line/infoline). However, you
can also print the current screen content (see %H
,
and %H.
below).
You have the following options:
Command | Function |
---|---|
%H |
This command activates the hardcopy output. The hardcopy
output is deactivated when either an If No selection window is displayed for the definition
of the output destination; instead, the printer specified with the profile
parameter |
%Hdestination |
Same as %H , but the printing
destination is specified with destination. The
destination can be 1 to 8 characters long.
|
%H, |
All subsequent %H commands
apply to the current screen.
|
%H. |
All subsequent %H commands
apply to the current logical page (applies by default).
|
%H=
|
This command activates/deactivates (toggle switch) the logging of all following pages. Logging means that all pages, which are displayed on the screen are forwarded to the printing destination as well. This feature may be used, for example, to log a sequence of output for administrative, debugging or educational purposes. For the hardcopy output, the printer specified with
the profile parameter |
%H=destination
|
Same as %H= , but the printing
destination is specified with destination. The destination can be 1 to 8
characters long.
|
%H#destination
|
With
|
%H-
|
Deactivates the hardcopy output immediately.
Note: |
Note:
The EJECT
statement does not affect the %H
command. The
%H
command always causes Natural to advance
pages.