Steps for using scenario blocks
The general steps for using scenario blocks are as follows:
1. Define and save the source scenario.
2. Generate a block from the source scenario to create your scenario block. This makes your new scenario block available for selection in the Catalogs tab.
3. Define a main scenario.
4. Add your scenario block to your main scenario.
5. In your main scenario, define rules that refer to your scenario block.
6. Deploy the source scenario. You can do this in Software AG Designer, or by injecting the .sdf file into the correlator with the engine_inject utility. If the source scenario requires any event types or other EPL to be injected before you can run it, be sure to inject those items before you try to run the main scenario.
7. Deploy the main scenario.
Contact Support
|
Community
|
Feedback