Analytics Builder 10.14.0 | Using Analytics Builder for Cumulocity IoT | Using the Model Manager | Editing an existing model
 
Editing an existing model
You can edit (or view) each model that is currently listed in the model manager.
If a model is in the Active state, editing will set the model to read-only mode. In this case, the model editor only allows you to view the contents of the model (for example, you can view the block parameters). You can navigate and zoom the model as usual, but you cannot change anything. The save button in the model editor is therefore disabled.
*To edit a model
*On the Models tab of the model manager, simply click the card that is shown for the model (but not on the toggle button for changing the state or the drop-down menu for changing the mode).
Or click the actions menu of the card and then click Edit.
If the model is in the Active state, a dialog appears informing you that you can only view the model. When you click Continue, the model editor appears and you can view the model, but you cannot change it.
See Using the Model Editor for further information.
Note: 
If you do not have sufficient permissions (that is, you only have READ permission for "CEP management" instead of ADMIN permission), the actions menu provides a View command instead of the Edit command.