COR Daemon Runtime Parameters

The following Adabas Fastpath parameters can be entered using DDCARD input in the Adabas System Coordinator daemon.

File Parameters
AFP AUDITING
AFP LAP
AFP V64BIT
AFP SAAMODE
AFP SAASIZE
AFP CORAUDID
AFP ALSAUDID

AFP AUDITING

Parameter Type Use Possible Values Default
COR Daemon runtime parameter

Controls the activation of Adabas Auditing support by the Fastpath Asynchronous Buffer Manager hosted by this COR Daemon.

AFP AUDITING=YES will activate support for Adabas Auditing.

NO | YES NO

AFP LAP

Parameter Type Use Minimum Maximum Default
COR Daemon runtime parameter

Controls the size of the Audit Pool (in KB).

Default size is 100MB, minimum size is 20MB, maximum size is 1GB.

If the Audit Pool becomes full, direct-access optimization for new records will be suspended until space becomes available. Console message AFP-0084-04 will be issued when the Audit Pool becomes 80% and 100% full.

This parameter is only applicable when AFP AUDITING=YES.

20480 1048576 102400

AFP V64BIT

Parameter Type Use Possible Values Default
COR Daemon runtime parameter

Controls whether the Audit Pool (AFP LAP=) resides in 31-bit memory or 64-bit memory.

AFP V64BIT=YES allocates the Audit Pool in 64-bit memory.

This parameter is only applicable when AFP AUDITING=YES.

NO | YES YES

AFP SAAMODE

Parameter Type Use Possible Values Default
COR Daemon runtime parameter

Controls the number of Staged Audit Areas for each Set.

AFP SAAMODE=M (for Multi) is intended to minimize the reduction in direct-access optimization for very active Sets; however, this does require greater memory usage within the Fastpath Buffer.

AFP SAAMODE=S (for Single) will minimize the required Fastpath Buffer memory; however, direct-access optimization may be reduced for very active Sets.

This parameter is only applicable when AFP AUDITING=YES.

S | M M

AFP SAASIZE

Parameter Type Use Minimum Maximum Default
COR Daemon runtime parameter

Controls the size of each Staged Audit Area (in KB).

These areas are associated with each individual Set and are allocated out of the Fastpath Buffer.

This parameter is only applicable when AFP AUDITING=YES.

1 128 8

AFP CORAUDID

Parameter Type Use Possible Values Default
COR Daemon runtime parameter

This parameter overrides any Audit Server ID(s) read from Adabas nucleus ADAANP parameters.

Any Audit Server ID specified by this parameter will be used as the target for all audit data gathered by the Fastpath Buffer Manager running within this COR Daemon.

This parameter may be useful in a multi-LPAR environment to minimize audit data sent across the network.

This parameter is only applicable when AFP AUDITING=YES.

nnnnn None

AFP ALSAUDID

Parameter Type Use Possible Values Default
COR Daemon runtime parameter

This parameter overrides any Audit Server ID(s) read from ALS nuclei ADAANP parameters.

Any Audit Server ID specified by this parameter will be used as the target for all ALS nuclei audit data gathered by the Fastpath Buffer Manager running within this COR Daemon.

This parameter may be useful in a multi-LPAR environment to minimize ALS nuclei audit data sent across the network.

This parameter is only applicable when AFP AUDITING=YES.

nnnnn None

On this page