The Entire Net-Work CTCA line driver and FCTC line driver currently support the z/OS operating system only. The following table describes most of the libraries included on the release media. Once you have unloaded the libraries from the media, you can change these names as required by your site, but the following lists the names that are delivered when you purchase Entire Net-Work CTC Option.
Note:
The complete list of libraries provided with Entire Net-Work can be found
in the full Entire Net-Work documentation.
| Library Name | Description |
|---|---|
| WCCvrs.LOAD | The z/OS load library for Entire Net-Work CTC Option. The vrs in the library name represents the version of Entire Net-Work CTC Option. |
If Entire Net-Work is not already installed, follow the instructions in the section Entire Net-Work Installation . Then perform the following additional steps:
Using IEBCOPY, unload the Entire Net-Work CTCA line driver or FCTC line driver library from the installation media into your Entire Net-Work load library.
Refer to the cover letter accompanying your installation media and to the Software AG Product Delivery Report for information about media format.
The library contains the following modules:
| NETCTCA | The CTCA line driver module |
| NCHXAR | The CTCA line driver attention routine module |
| NETFCTC | The FCTC line driver module |
| NCHXARF | The FCTC line driver attention routine module |
Add DRIVER and LINK statements that specify your requirements to the Entire Net-Work parameter data set.
For an example, see the section Sample JCL and Parameter Statements.
The CTCA line driver and FCTC line driver require APF authorization. To make Entire Net-Work APF-authorized, ensure that:
all load libraries in your STEPLIB concatenation have been defined to z/OS as authorized libraries; and
module ADARUN has been linked with AMODE(31) and AC(1).
Start Entire Net-Work (on multiple nodes) and run verification tests, such as executing operator commands and accessing remote databases.