Introduction to installation verification

After the CONNX installation runs to completion, the first verification step is to check that all job steps completed with condition codes less than or equal to four.  A successful installation of the CONNX Started Task components creates 76 data sets with the default user-modifiable prefix of CONNX.STASK. The CONNX VSAM / QSAM / PDS  test data sets are created with a default user-modifiable prefix of CONNX.STASK.SAMPLES. These test data sets are for demonstration purposes only, and can be safely deleted. The minimal complement of data sets necessary to run CONNX for VSAM / QSAM / PDS, given the default data set prefix of CONNX.STASK, is as follows:

CONNX.STASK.CNTL

CONNX.STASK.OBJECT

CONNX.STASK.LOAD

The following sections enumerate the manual steps necessary to complete the installation of the started task components of CONNX for VSAM / QSAM / PDS.