9158E

9158E BSA INITIALIZATION FAILED (info)

Written to:

Operator console.

Explanation:

Depending on info:

• INCONSISTENT LEVEL: newlvl/oldlvl

  The level consistency check at product start has detected that the BSA components that are used are not compatible (for example, BSA modules in BETA.APFLOAD and BSA.LOAD have different levels). newlvl is the level of the BETA.APFLOAD and oldlvl is the level of the BSA.LOAD.

• INCONSISTENT LEVEL: bsalvl/modlvl/modname

  The BSA level bsalvl (1771-03 or later) and the level of the module modname with module level modlvl do not match. The minimum required modlvl is V7R1M3. This problem is typically caused by an installation problem affecting BSA level bsalvl.

• PARM BnnLST INVALID

  The specification for BnnLST in the EXEC parm is invalid. The reason may be a syntax error or a level mismatch, i.e. the BST01SFF/BST01RFF level that is used to start the subsystem is lower than the actual BSA level bsalvl (1771-03 or later).

• MAXIMUM NUMBER nn OF LST-MEMBER EXCEEDED

  The maximum number of concatenated LST members (B01LSTxx plus BnnLSTxx) is exceeded.

• LST-MEMBER CONCATENATION NOT ACTIVATED

  Concatenated LST members were specified in the EXEC parm, but the product does not allow this by default. The LST parameter Bnn_LST_CONCAT_SUPPORT = YES can be coded to activate the support of concatenated LST members outside the basic product support (see BSA Installation and System Guide).

System Action:

The subsystem ends with RC=16.

Operator Response:

Determine the reason for the error, eliminate it, and restart the subsystem. If the error persists, please contact support.