The following table describes the reason codes that are returned during subsystem initialization. These codes occur in BSA message range 9100 through 9199.
RC |
Description |
---|---|
4 |
The subsystem ID ssid was not initialized correctly or was not initialized at all by means of the program BST01ARI. The SSVT is missing. |
8 |
The subsystem ID ssid was initialized with a wrong version of the program BST01ARI. The Beta SVC used with the start of the STC is not compatible with the program BST01ARI. A wrong version of the SSCA was found. |
12 |
The subsystem ID ssid was not initialized correctly by means of the program BST01ARI or a wrong version of the program BST01ARI was used during the initialization. The Beta-specific XCFA was not found. |
16 |
The subsystem ID ssid was not initialized correctly or was not initialized at all by means of the program BST01ARI. The SSCA could not be found. |
24 |
The subsystem ID ssid was initialized with a wrong version of the program BST01ARI. The Beta SVC used with the start of the STC is not compatible with the program BST01ARI. A wrong version of the SSCA was found. |
28 |
The subsystem ssid is using BSA V7, but the subsystem was initialized with a previous version of the program BST01ARI. If BSA V7 is used, subsystems must be initialized with the program BST01ARI that is provided with BSA V7. |
32 |
The subsystem ssid is using BSA V7, but the specified SVC is not compatible with BSA V7. BSA V7 requires the use of the BSA V7 SVC. |
36 |
The subsystem ssid is using BSA V7, but the module BST01SFF/BST01RFF is from a previous version of BSA. BSA V7 requires the use of the modules BST01SFF and BST01RFF that are provided with BSA V7. |