9221I
SYSLOG, JESMSGLG.
The MODIFY command F stcname,DISPLAY OCF,ALL has been entered. All the relevant information on existing OCF connection(s) is output as follows:
|
lssid |
Local subsystem ID from the LST parameter OCF_LOCAL_SYSTEM When the subsystem ID of the Beta started task is used, an asterisk (*) is displayed here, e.g. B02A*. # following the SSID means that this is an XCF-initialized SSID. |
|
rssid |
Remote subsystem ID supported via this OCF connection. # following the SSID means that this is an XCF-initialized SSID. |
|
loc |
Status of the local subsystem ID: ACT Active INA Inactive RTY Retry PND Pending |
|
rem |
Status of the remote subsystem ID: ACT Active INA Inactive RTY Retry REX Retry exceeded PND Pending When RTY or REX is displayed, an asterisk (*) will be displayed in the lines RSB-ENTRYS and RST/LST-ENTRYS. The information displayed in these lines then shows the status of the previous OCF connections and subsystems. |
|
con |
Status of the OCF connection: ACT Active INA Inactive RTY Retry REX Retry exceeded PND Pending When RTY or REX is displayed, an asterisk (*) will be displayed in the lines RSB-ENTRYS and RST/LST-ENTRYS. The information displayed in these lines then shows the status of the previous OCF connections and subsystems. |
|
lapplid |
Local OCF APPLID If OCF via TCP/IP: identifier of the TCP/IP port connection. The name (mm#nnnnn) consists of the number 00 plus the separator # plus the port number specified in the LST parameter BSA_OCF_
|
|
rapplid |
Remote OCF APPLID, as specified in the LST parameter OCF_CONVERSE If OCF via TCP/IP: identifier of the TCP/IP port connection. The name (mm#nnnnn) consists of a two-digit sequential number plus the separator # plus the port number specified in the LST parameter BSA_OCF_
|
|
rusz |
Size of the used RU size for this OCF connection |
|
cnt |
Number of Retry cycles as specified by LST parameter OCF_CONVERSE or BSA_OCF_
|
|
acnt |
Current number of executed retry attempts |
|
int |
Size of the interval between two retry attempts as specified by LST parameter OCF_CONVERSE or BSA_OCF_
|
|
sess |
Number of defined sessions as specified by LST parameter OCF_CONVERSE |
|
log mode |
Name of the log mode used for the connection. The value must always be APPC01 |
|
status |
Status of rssid, rapplid or lassid |
|
sysname |
Name of the system on which the rssid is located. |
|
lassid |
Local subsystem ID supported by OCF APPLID rapplid |
|
job name |
Job name of the Beta STC in accordance with the subsystem ID |
|
jesid |
JES ID of the Beta STC |
|
membername |
XCF member name given to the SSID when it joined XCF. |
|
asysname |
System name on which the Beta STC with the subsystem ID lassid is active. |
|
token |
XCF token created by XCF for the SSID that joined under membername. |
|
ascb |
ASCB address of the Beta STC |
|
ipaddress |
IP address of the connection |
The system continues operating.
None.