LST parameters in B01LSTxx

LST parameters in B01LSTxx

Note

The following parameters must be specified in the B01LSTxx member. We recommend that you code them only once and use the same B01LSTxx member for all the Beta products that are installed.

Parameter name

Value

Description

Opt./Req.

Default

SVC

nnn

Installation-defined SVC number used by the Beta SVC

Required

 

A2G_SUPPORT

YES | NO

Enables the BQL DB cache to be used above the 2GB limit (e.g. use of main storage "above the bar") – 64 bit. If A2G_SUPPORT is active, but no storage or insufficient storage is available above the bar, the Beta product will not be started.

IBM states: "You can set a limit on how much virtual storage above the bar each address space can use. This limit is called the MEMLIMIT. If you do not set MEMLIMIT, the system default is 0, meaning no address space can use virtual storage above the bar. If you want to use virtual storage above the bar, you need to set the MEMLIMIT explicitly. You can set an installation default MEMLIMIT through SMFPRMxx in PARMLIB or via SETSMF command. You can also set MEMLIMIT for a specific address space in the JCL that creates the address space or by using SMF exit IEFUSI."

Please refer to the IBM literature for further information.

Optional

NO

ARM_SUPPORT

ALL | STC | BATCH

The Automated Restart Manager of the operating system is used for the selected parameter (see "Automatic restart management (ARM) support").

Optional

none

ARM_EVENT_EXIT

name

Name of the event exit used to prepare for the restart of an element, or to prevent the restart of an element.

A sample exit in source form can be found in the BSA.SAMPLIB in member BST01AEX.

Optional

IEFBR14

SYSVAR_SUPPORT

YES | NO

Switches support for static system symbols (SYSVAR) on or off (see "Static system symbol support")

Optional

NO

DUMP_COUNTER

1..20

Number of SFF dumps to be written after an abend occurs. The maximum number is 20. If you specify a number >20, one dump will be written.

Optional

3

ESTAE

YES | NO

Switches BSA abend recovery on or off. Do not deactivate this parameter unless asked to do so by Beta Systems support. When this parameter is switched OFF, every abend will terminate the started task.

Optional

YES