DCAM Feedback Codes

Code Explanation
0C04 Application not connected with partner. LOSCON contingency processing is probably pending.
0C40

Connection was refused by partner without reason. With TRANSIT-CD (Entire Net-Work VTAM):

Line was deactivated (INACT); e.g., /DADM PX25,vr,RESET,vr11r7.

0C48

Time-out for connection request. With TRANSIT-CD (Entire Net-Work VTAM):

Cross-domain session did not notice IPL on IBM side; e.g., /DADM PNET,vr,ACT,siehost,siegat.

0C4C

DCAM partner application not active.

0C5CXX

OPNCON was rejected by partner:

  • 00:  

  • 18: Application not active on SISNIX (via HDLC). ISO=Y on X.25 link.

  • 2: Partner rejects connection; partner has different information (NAME) for this application; or ISO application wanted to connect to a non-ISO application.

  • 5C: Application not active via X.25; or an X.25 "call-user-data" was probably required.

0C78

Immediately after connection installation, the partner or system disconnected.

ISO parameter missing.

1840

Invalid processor name:

  • Check that the processor name is in RDDF;

  • Issue a /BCIN command.

100408

BDCAM buffer shortage.

DCAM driver waits for 5 seconds and retries operation. When GO signal is not used. retry is scheduled after DCAM has given the GO signal.

10040C

BDCAM buffer shortage. Wait for GO signal.