ADAL* - Command Log (CLOG) System Messages

The command log is sequential, and the DDLOG data set was either set to "dummy" or could not be opened. Command logging is switched off.

The specified command log for dual or multiple command logging is now active.

Command logging has switched to data set DD/CLOGRn .

The specified dual or multiple command logging data set is being overwritten with new log data, and is no longer valid. Normally, the from and to blocks and the from and to timestamps being overwritten are given in the message. However if there was a problem obtaining this block and timeout information, the 00199 messages listed above may be issued.

Command logging to data set DDCLOGRn was terminated by an I/O error .

None of the dual or multiple command logging data sets was available (presently being copied by ADARES) . Command logging is switched off.

An invalid command logging device or size was specified, or an I/O error on either the first or last block was detected. Command logging is switched off.

In a cluster nucleus, a second nucleus has been started with the same CLOG file name as one of the other nuclei in the cluster.

Check the CLOG file names used in the cluster and allocate another CLOG file to one nucleus in the cluster to correct the duplication.

An error occurred while processing the parallel participant table (PPT). The nucleus stays up, but command logging is disabled.

Collect diagnostic information such as that provided by the ADACHK PPTPRINT function. Provide the error number (nn) and the PPTPRINT to your Software AG technical support representative. It may be necessary to format the PPT and restart the nuclei in order to rebuild the PPT.

Either the CLOG data sets are different from what was specified in the last session or no CLOGs are specified but the previous CLOGs were not copied. The PPT information about these data sets is being overwritten.

If the contents of the CLOGs are still needed, they must be copied with the CLCOPY function and then merged manually. If the contents are not needed, no action is required.

This message is generated if an attempt is made to initialize a non-plex/ASM nucleus (NUCID=0) with CLOGMRG=YES specified. This is an informational message only and the nucleus will come up. CLOGMRG=YES should only be specified if NUCID is greater than 0.

No action is required for this informational message.

An ADADBS REACTLOG request is not allowed. If there are no outstanding I/Os for the command logs, then the request to reactive the log is not allowed. The database ID associated with the command log (dbid) and the date and time stamp are given in the message.

Try again when there are outstanding I/Os for the command logs.

A request to reactivate command logging was successful. The database ID associated with the command log (dbid) and the date and time stamp are given in the message.

No action is required for this informational message.

A request to reactivate command logging failed. This message should be preceded by another error message describing the reason for the failure. The database ID associated with the command log (dbid) and the date and time stamp are given in the message.

Review the other messages to resolve the problem and try again. If the problem persists, contact your Software AG technical support representative for assistance.

A request for storage failed. Command logging is halted. The database ID associated with the command log (dbid) and the date and time stamp are given in the message.

Contact your Software AG technical support representative for assistance.