ADAFRM Utility Messages

At least one of the following functions must be specified: ASSOFRM, DATAFRM, WORKFRM, CLOGFRM, PLOGFRM, RLOGFRM, TEMPFRM, SORTFRM, DSIMFRM, ASSORESET, DATARESET, WORKRESET, or DSIMRESET.

Supply the correct parameter value and rerun the ADAFRM job.

See the Adabas Utilities documentation for a description of data set numbers.

Supply the correct parameter value and rerun the ADAFRM job.

Resetting Associator blocks with the range 1-30 is rejected.

Job control statements defining the Associator must be included for both the ADAFRM utility job for the ASSOFRM, DATAFRM, TEMPFRM and WORKFRM functions when the FROMRABN parameter is specified, and when running the ASSORESET, DATARESET, and WORKRESET ADAFRM functions.

Supply the required JCL/JCS job control, and rerun the ADAFRM job.

The SIZE value specified with FROMRABN=NEXT is not valid. The range of blocks to be formatted in not contained in the free space table.

Supply a valid SIZE parameter value and rerun the job.

For the ASSOFRM and DATAFRM functions, valid FROMRABN values include a numeric starting RABN value or FROMRABN=NEXT.

Supply a valid FROMRABN value and rerun the job.

An invalid value was specified for the VOLIOCOUNT parameter. VOLIOCOUNT must be a numeric value. Refer to the ADAFRM parameter descriptions in the Adabas Utilities Manual for the range of valid values.

Supply a valid VOLIOCOUNT value and rerun the job.

An attempt to format the same data set from the start multiple times has been detected. The same data set cannot be formatted more than once in a single execution of ADAFRM.

Supply valid data set information and rerun the job.