NETU* - Batch Utility Program Messages

An error occurred while trying to open file xxxxxxx (DDCARD, NETFILE, or DDPRINT) and the file could not be opened. This error causes the utility program to terminate with a return code of 8.

Look at the job log or system log for additional system messages that indicate why the file could not be opened.

NETPFIL1, NETPFIL2

An error occurred while trying to read from file xxxxxxx (DDCARD or NETFILE). This error causes the utility program to terminate with a return code of 8.

Look at the job log or system log for additional system messages that indicate the cause of the I/O error.

NETPFIL1, NETPFIL2

An error occurred while trying to write to the DDPRINT file. This error causes the utility program to terminate with a return code of 8.

Look at the job log or system log for additional system messages that indicate the cause of the I/O error.

NETPFIL1, NETPFIL2

An error occurred while trying to close file xxxxxxx (DDCARD, NETFILE or DDPRINT). This error causes the utility program to terminate with a return code of 8. The files are not closed until the end of the program, so the output file may or may not contain the desired data.

Look at the job log or system log for additional system messages that indicate the cause of the I/O error.

NETPFIL1, NETPFIL2

A FIND parameter was specified with an invalid syntax. This probably means that the OFFSET or VALUE keywords were not specified or were specified out of order.

Correct the FIND parameter using the following syntax:

FIND=logging title,OFFSET=nnn,VALUE=characters
FIND=logging title,OFFSET=nnn,VALUE=X'hex values'

NETPFIL2

The OFFSET specified on a FIND parameter did not contain a valid hexadecimal displacement. The displacement value must be a valid hexadecimal number containing only 0-F.

Correct the FIND parameter OFFSET=xxx to a valid hexadecimal displacement.

NETPFIL2