Version 8.2.5
 —  Messages and Codes  —

DCAM Feedback Codes

Code Explanation
0C04 Application not connected with partner. LOSCON contingency processing is probably pending.
0C40

Connection was refused by partner without reason. With TRANSIT-CD (Entire Net-Work VTAM):

Line was deactivated (INACT); e.g., /DADM PX25,vr,RESET,vr11r7.

0C48

Time-out for connection request. With TRANSIT-CD (Entire Net-Work VTAM):

Cross-domain session did not notice IPL on IBM side; e.g., /DADM PNET,vr,ACT,siehost,siegat.

0C4C

DCAM partner application not active.

0C5CXX

OPNCON was rejected by partner:

  • 00:  

  • 18: Application not active on SISNIX (via HDLC). ISO=Y on X.25 link.

  • 2: Partner rejects connection; partner has different information (NAME) for this application; or ISO application wanted to connect to a non-ISO application.

  • 5C: Application not active via X.25; or an X.25 "call-user-data" was probably required.

0C78

Immediately after connection installation, the partner or system disconnected.

ISO parameter missing.

1840

Invalid processor name:

  • Check that the processor name is in RDDF;

  • Issue a /BCIN command.

100408

BDCAM buffer shortage.

DCAM driver waits for 5 seconds and retries operation. When GO signal is not used. retry is scheduled after DCAM has given the GO signal.

10040C

BDCAM buffer shortage. Wait for GO signal.

Top of page