Version 8.2.5
 —  Messages and Codes  —

ADAZAP Utility Error Messages

Overview of Messages

ERROR-121 | ERROR-122 | ERROR-123 | ERROR-124 | ERROR-125 | ERROR-126 | ERROR-127 | WARNING-128

ERROR-121 Incorrect mastercode supplied
Explanation

The 8-byte mastercode specified in the MCODE parameter is incorrect.

Action

Supply the correct mastercode and rerun the job.


ERROR-122 Adabas active, ADAZAP not permitted to run
Explanation

ADAZAP runs only when the relevant Adabas nucleus is inactive.

Action

Shut down the nucleus and rerun the job.


ERROR-123 VER-string is shorted than REP-string
Explanation

The length of the string specified by VER is shorter than the string specified by REP.

Action

Specify the length of VER at least as long as the length of REP.


ERROR-124 VER and LENGTH are mutually exclusive
Explanation

The VER parameter and the LENGTH parameter may not be specified at the same time.

Action

Specify either VER or LENGTH, but not both.


ERROR-125 OFFSET is bigger than BLOCKLENGTH
Explanation

The OFFSET value specified is greater than the block length.

Action

Specify a smaller OFFSET value so that it falls within the block.


ERROR-126 Verify not matched, string was: string
Explanation

The VER value specified did not match.

Action

Specify the correct VER value and rerun the job.


ERROR-127 offset plus length-of-verification exceeds block length
Explanation

The of the two values offset plus the length-of-verifcation string exceeds the maximum block size of the RABN being modified.

Action

Check your VER value and specify an offset and a string that falls completely within the block.


WARNING-128 End of block reached
Explanation

During a list function, the offset plus the length specified exceeded the block size.

Action

No action is required for this warning message.


Top of page