Note:
Each of the messages in this section starts with the relevant database
ID.
ADAE01 | ADAE02 | ADAE03 | ADAE04 | ADAE05 | ADAE06 | ADAE07 | ADAE08 | ADAE12 | ADAE15 | ADAE16 | ADAE17 | ADAE18
ADAE01 | Unable to load required modules |
Explanation |
A required module could not be loaded. Operation terminates with an abend U0042. |
Action |
Check that the modules NA2PMAC and ESICFG are available. |
ADAE02 | Unable to allocate required storage |
Explanation |
There is insufficient storage available for ADASAF to operate. Operation terminates with an abend U0042. |
Action |
Increase the amount of storage (above the 16-megabyte line) available to the failing job. |
ADAE03 | Unable to allocate NRS storage |
Explanation |
ADASAF needs approximately two KB of storage below the 16-megabyte line. If the storage is not available at initialization (or after a newcopy operator command), ADASAF issues this message and operation terminates. |
Action |
Ensure that enough storage is available. |
ADAE04 | Module module-name not loaded |
Explanation |
The indicated module could not be loaded during initialization or during the newcopy operator command. If the module is required (rather than optional), operation terminates. |
Action |
Ensure that the module is available. |
ADAE05 | Invalid parameters detected |
Explanation |
One or more invalid parameters were specified in DDSAF. Operation terminates. |
Action |
Correct the invalid parameters. |
ADAE06 | Allocation of user file cache failed |
Explanation |
ADASAF allocates a user file cache above the 16-megabyte line. If the storage is not available at initialization (or after a newcopy operator command), ADASAF issues this message and operation terminates. |
Action |
Ensure that enough storage is available or reduce the MAXFILES parameter (this may adversely affect performance). |
ADAE07 | input-parameter |
Explanation |
ADASAF echoes the parameters read from DDSAF for information and auditing purposes. |
ADAE08 | Invalid parameter: input-parameter |
Explanation |
ADASAF detected incorrect input in DDSAF. ADAE08 is issued for each invalid parameter found and is followed by ADAE05. |
Action |
Correct the invalid parameter. |
ADAE12 | ADASAF is active in {FAIL|WARN} mode |
Explanation |
ADASAF has successfully initialized in the mode indicated. |
ADAE15 | NEWCOPY of parameter module failed |
Explanation |
After a NEWCOPY operator command, ADASAF was unable to reload ESICFG. Operation terminates. |
Action |
This error occurs only if there is a shortage of storage or the module ESICFG was deleted from the load library after initialization. Determine which of these is the case and correct it. |
ADAE16 | NEWCOPY reinitialization failed |
Explanation |
This message appears after a failure during NEWCOPY processing. It should be accompanied by a more detailed error message specifying the nature of the failure. |
Action |
Take the action recommended by the accompanying message. |
ADAE17 | Not APF-authorized |
Explanation |
ADASAF must run APF-authorized. Operation terminates. |
Action |
Check that all STEPLIBs are in the APF list and that ADARUN is linked with AC(1). |
ADAE18 | No security details for job job-name |
Explanation |
An Adabas command received from the named job had no security credentials attached to it. The command is rejected with response code 200 (ADARSP200), subcode 3. |
Action |
Ensure that the security exits are correctly installed in the Adabas SVC and that the source job has been configured correctly to support SAF security systems. |