Version 8.2.4
 —  Messages and Codes  —

ARMT* - Adabas Review Interface Messages

Overview of Messages

ARMT01 | ARMT02 | ARMT03 | ARMT04 | ARMT05

ARMT01 dbid GETMAIN FAILURE, SIZE requested-getmain-size
Explanation

A request for storage in the Adabas nucleus failed.

Action

Either determine what is using so much storage in the Adabas nucleus and correct the problem; or increase the available storage.


ARMT02 dbid ATTACH ADARST FAILURE, STRS nn
Explanation

The Adabas nucleus was unable to attach the subtask ADARST. STRS is the ADAIOR response code.

Action

Probably, the module ADARST is missing.


ARMT03 dbid CLOG TOO BIG, CLOG NOT SENT
Explanation

When an ADABAS nucleus runs Adabas Review in hub mode, the CLOG inclusive CLOG extension and control information may be bigger than around 32K. This CLOG record is not sent to the Adabas Review hub. This message is only issued one time.

Action

One of the buffers may be too big. For instance, you may set LOGRB=NO.


ARMT04 dbid ATTACH OF ADARST SUCCESSFUL
Explanation

The subtask ADARST was attached successfully. The database will send data to the Adabas Review hub.

Action

No action is required for this informational message.


ARMT05 dbid DETACH OF ADARST SUCCESSFUL
Explanation

The subtask ADARST was detached successfully.

Action

Once you have corrected the error that led to detachment of ADARST, you can reactivate the subtask using the ADARUN parameter REVIEW=hubid. The successful ATTACH will be acknowledged with message ARMT04. A restart of the database is in this case not necessary.

If the subtask abends a second time, it will be deactivated completely and message ARST10 will be given.


Top of page