Version 2.3.1
 —  Messages and Codes  —

Introduction

This documentation provides you with all information related to error situations in the ADL environment.

The installation of the ADL system is described in the ADL Installation documentation . The conversion of DL/I data bases is described in the ADL Conversion documentation. Finally, the installation and operation of the CALLDLI and Consistency Interfaces is covered by the ADL Interfaces documentation .

In addition to a list of error messages issued by ADL, the documentation provides information on the general error handling procedures of ADL and in particular the error handling of the CALLDLI and the Consistency Interfaces. The section Problem Analysis is intended to help you to cope with error situations.

For your convenience, a glossary of terms used in the ADL documentation is included.

This document covers the following topics:


Other documentations You May Need

The following Software AG publications may be useful when installing and operating the ADL Interface:

For a complete list of Software AG documentation, refer to Software AG's Empower web site. If you do not have an Empower user ID and password yet, you will find instructions for registering on this site (free for customers with maintenance contracts).

Top of page

Documentation Related to non-SAG Products

The documentation mentioned below might be of interest and helpful for the installation and operation of ADL.

For z/OS users:

For z/VSE users:

Top of page