This documentation provides you with all information related to error situations in the ADL environment.
The installation of the ADL system is described in the
ADL Installation documentation
. The conversion of DL/I data bases is described in the
ADL Conversion documentation.
Finally, the installation and operation of the CALLDLI and
Consistency Interfaces is covered by the
ADL Interfaces
documentation .
In addition to a list of error messages issued by ADL, the documentation
provides information on the general error handling procedures of ADL and in
particular the error handling of the CALLDLI and the Consistency
Interfaces. The section Problem Analysis is intended to help you
to cope with error situations.
For your convenience, a glossary of terms used in the ADL documentation is included.
This document covers the following topics:
The following Software AG publications may be useful when installing and operating the ADL Interface:
Adabas Utilities documentation
Adabas Operations documentation
Adabas Messages and Codes documentation
Adabas Reference Data and Adabas DBA Reference Data documentation.
For a complete list of Software AG documentations, prices, and ordering information refer to the Software AG Documentation Overview or contact your Software AG support representative.
The documentation mentioned below might be of interest and helpful for the installation and operation of ADL.
For z/OS users:
IMS/VS Application Programming
IMS/VS Application Programming for CICS/VS Users
IMS/VS Utilities Reference documentation
CICS TS Installation Guide
CICS TS Operations and Utilities Guide
CICS TS Resource Definition Guide
For z/VSE users:
DL/I DOS/VS Guide for New Users
DL/I DOS/VS Application Programming: CALL and RQDLI Interface
DL/I DOS/VS Application Programming: High Level Programming Interface
DL/I DOS/VS Utilities and Guide for the System Programmer
DL/I DOS/VS Resource Definition and Utilities
CICS TS Installation Guide
CICS TS Operations and Utilities Guide
CICS TS Resource Definition Guide
